平面波输入下海水-海床-结构动力相互作用分析

海洋工程结构的地震反应分析是保证海洋工程结构地震安全的重要环节.由于其所处的复杂环境, 该问题涉及到流固耦合和土-结相互作用.本文基于海水、饱和海床、基岩流固耦合统一计算框架,采用Davidenkov模型和修正的Masing准则考虑饱和海床的非线性,在脉冲SV波垂直入射下, 进行了海域场地和海洋工程结构的动力响应分析. 首先,对比分析了线性自由场和非线性自由场输入情形的海域场地非线性反应,结果表明线性自由场输入时反应不合理,自由场分析和场地分析应该采用相一致的本构模型. 然后,对比分析了海床分别为线性和非线性情形时,海域场地以及海水-海床-结构体系的反应特征. 与线性海床情形相比,非线性对海床反应的影响主要由如下两方面因素控制: 一方面,非线性导致饱和海床模量减小, 饱和海床与基岩间的波阻抗比减小,由基岩到饱和海床间的反射系数和透射系数增加, 导致反应增大; 另一方面,非线性导致阻尼加大, 使海床反应减小. 对于本文算例而言,阻尼对非线性海床结果的影响占主导作用.      

Optimisation of the ultrasound-assisted extraction of betalains and polyphenols from Amaranthus hypochondriacus var. Nutrisol

The present study optimised the ultrasound-assisted extraction (UAE) of bioactive compounds from Amaranthus hypochondriacus var. Nutrisol. Influence of temperature (25.86–54.14 °C) and ultrasonic power densities (UPD) (76.01–273.99 mW/mL) on total betalains (BT), betacyanins (BC), betaxanthins (BX), total polyphenols (TP), antioxidant activity (AA), colour parameters (L*, a*, and b*), amaranthine (A), and isoamaranthine (IA) were evaluated using response surface methodology. Moreover, betalain extraction kinetics and mass transfer coefficients (K_La) were determined for each experimental condition. BT, BC, BX, TP, AA, b*, K_La, and A were significantly affected (p < 0.05) by temperature extraction and UPD, whereas L*, a*, and IA were only affected (p < 0.05) by temperature. All response models were significantly validated with regression coefficients (R²) ranging from 87.46 to 99.29%. BT, A, IA, and K_La in UAE were 1.38, 1.65, 1.50, and 29.93 times higher than determined using conventional extraction, respectively. Optimal UAE conditions were obtained at 41.80 °C and 188.84 mW/mL using the desired function methodology. Under these conditions, the experimental values for BC, BX, BT, TP, AA, L*, a*, b*, K_La, A, and IA were closely related to the predicted values, indicating the suitability of the developed quadratic models. This study proposes a simple and efficient UAE method to obtain betalains and polyphenols with high antioxidant activity, which can be used in several applications within the food industry.     

锰离子氧化沉淀法实现锂离子电池LiNi0.8Co0.05Mn0.15O2材料的回收和利用

以浓盐酸为浸出剂,以NaOH和NH₄HCO₃为沉淀剂,利用Mn²⁺在碱性条件下的氧化反应改变离子的沉淀次序进而分步回收的方案,探究了浓盐酸酸浸处理三元正极材料LiNi_0.8Co_0.05Mn_0.15O₂的最佳条件。在分步沉淀过程中,Mn²⁺被氧化为不溶于非还原性酸的MnO （OH）₂,并在酸性条件下回收。Ni、Co则在碱性条件下利用NaOH回收,而Li则利用NH₄HCO₃回收。该方法中Mn的回收率达到85.1%,产品纯度达到98.6%; Li的回收率达到95.0%,产品纯度达到99.3%。由回收材料重新合成的三元正极组装的软包电池的首圈放电比容量达到了175 mAh·g^-1,可以以超过99.5%的库仑效率稳定循环50圈。     

AEIV结合AHSI用于饱和脂肪酮类物质的13C NMR谱模拟

应用一种反映分子局部微环境描述子--原子电性相互作用矢量（vector of atomic electronegative interaction,AEIV）和原子杂化状态指数（Atomic Hybridation State Index, AHSI）对饱和脂肪酮类化合物的55种分子中的153个¹³C NMR谱建模模拟,应用多元线性回归方法得到定量结构波谱关系(QSSR)模型的复相关系数R_MM=0.997, 标准偏差为SD_MM=7.155. 采用留一法交互检验的结果是R_CV=0.993,SD_CV=10.195. 并随机抽出三部分分子进行检验,得到的相关系数分别是R_MM1=0.996,R_MM2=0.996,R_MM3=0.999. 研究结果表明使用AEIV和AHSI所建模型预测能力是相当稳定的.     

Transition Metal Free Chemoselective Reduction of α,β‐Unsaturated Ketones to Saturated Ketones Using Tosyl Hydrazide as a Hydrogen Donor

An efficient, inexpensive and simple method for the reduction of various α,β‐unsaturated ketones to corresponding saturated ketones using tosyl hydrazide as a hydrogen donor in DMF using calcium oxide powder has been reported. A variety of enones underwent reduction without forming undesirable side products. High chemoselectivity, broad functional group tolerance and good yields are the noteworthy features of this protocol.     

湿法脱硫浆液中Hg2+的还原机制研究

针对燃煤电厂湿法脱硫浆液中Hg²⁺易被还原的特性,研究Hg²⁺在模拟湿法脱硫系统中的迁移机制,考察了浆液温度、pH值以及SO₃^2-、Cl^-、Ca²⁺、Mg²⁺浓度等因素对Hg²⁺还原性能的影响。结果表明,Hg²⁺还原率随着浆液中SO₃^2-浓度的增大而降低;pH值对Hg²⁺的还原呈先增加后降低的趋势,在pH值为5.5时还原率最高;温度的升高不利于浆液中稳定的二价汞盐络合物存在,导致Hg²⁺还原率增加;Ca²⁺、Mg²⁺以及Cl^-浓度的增加有利于形成稳定化合物,从而抑制Hg²⁺的还原。     

超高效液相色谱法测定湿巾中7种防腐剂

建立超高效液相色谱法测定湿巾中7种防腐剂的检测方法。样品采用甲醇超声提取,色谱柱采用Waters ACQUITY UPLC BEH C_(18)柱(50 mm×2.1 mm,1.7μm),流动相为甲醇–乙酸水溶液(pH 3.3)梯度洗脱,初始流量为0.8 m L/min,用PDA检测器检测,检测波长分别为255,270,310 nm。以3倍空白噪音计,2-溴-2-硝基丙烷-1,3-二醇,苯酚,苯甲醇,苯氧乙醇,苯甲酸,山梨酸,脱氢乙酸的检出限分别为60.0,0.5,20.0,8.0,5.0,0.2,0.5 mg/kg;方法加标回收率为100.9%~109.3%;测定结果的相对标准偏差为0.2%~1.9%(n=6)。结果表明该方法处理简单,分离效果好,速度快,能快速准确测定湿巾中7种防腐剂。     

Well Oriented ZnO Nanorods Array: Negative Resistance and Optical Switching

Well‐oriented ZnO nanorods (NRs) arrays were grown on Si, alumina, quartz, and FTO substrates through a ZnO seed layer followed by low temperature wet chemical process. The influence of sputtered ZnO seed layer thickness (100, 50, 32, and 16 nm), annealing temperature and CuO_x coverage on the characteristics of ZnO NRs were investigated in this study. The crystalline structural, chemical, morphological, optical, and electrical properties of ZnO NRs arrays were studied by X‐ray diffraction (XRD), field emission‐ scanning electron microscopy equipped by energy dispersive X‐ray spectroscopy (FE‐SEM/EDX), Raman scattering, UV/Vis ‐ near IR absorption spectroscopy and current‐voltage characteristic. XRD and Raman spectra measurement revealed that the synthesize ZnO displayed hexagonal wurtzite structure. The individual rod diameter, density, and orientation can be controlled by varying the seed layer thickness. The mean diameter and maximum length of ZnO NRs are around 55–66 nm and 282 nm, respectively. ZnO NRs/ ZnO thin film structure shows optical switching and negative differential resistance behavior as applicable to ON/OFF gate and memory devices.     

Wet-Chemically Prepared Porphyrin Layers on Rutile TiO2(110)

Porphyrins are large organic molecules that are interesting for different applications, such as photovoltaic cells, gas sensors, or in catalysis. For many of these applications, the interactions between adsorbed molecules and surfaces play a crucial role. Studies of porphyrins on surfaces typically fall into one of two groups: (1) evaporation onto well-defined single-crystal surfaces under well-controlled ultrahigh vacuum conditions or (2) more application-oriented wet chemical deposition onto less well-defined high surface area surfaces under ambient conditions. In this study, we will investigate the wet chemical deposition of 5-(monocarboxyphenyl)-10,15,20-triphenylporphyrin (MCTPP) on well-defined rutile TiO₂(110) single crystals under ambient conditions. Prior to deposition, the TiO₂(110) crystals were also cleaned wet-chemically under ambient conditions, meaning none of the preparation steps were done in ultrahigh vacuum. However, after each preparation step, the surfaces were characterized in ultrahigh vacuum with X-ray photoelectron spectroscopy (XPS) and the result was compared with porphyrin layers prepared in ultrahigh vacuum (UHV) by evaporation. The differences of both preparations when exposed to zinc ion solutions will also be discussed.     

图形衬底对多周期InGaAs量子点自组装生长的影响

量子点器件技术广泛应用于量子计算和光电器件上.成核位置的均匀性、有序性和尺寸一致性,可以有效提高光电器件性能.为了实现阵列量子点的可控性,本文采用湿法刻蚀制备图形化衬底,理论上解释了铟原子在图形化衬底上成核现象,产生有序的量子点分布特征,发现图形衬底的缺陷诱导在平台边缘和沟壑边缘成核,形成较大的量子点.在Stranski-Krastanow模式下图形衬底制备多周期量子点,发现多周期生长可以弱化台阶结构对量子点分布的限制作用.